From 1cdad3d31a72395a0c74025376a0ba3f66a25c33 Mon Sep 17 00:00:00 2001 From: Bob Dougherty Date: Wed, 5 Jul 2000 00:45:01 +0000 Subject: [PATCH] bob: added comments to via686 section git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@831 7894878c-1315-0410-8ee3-d5d059ff63e0 --- etc/sensors.conf.eg | 15 +++++++++++++-- 1 file changed, 13 insertions(+), 2 deletions(-) diff --git a/etc/sensors.conf.eg b/etc/sensors.conf.eg index 8655b988..49668ecc 100644 --- a/etc/sensors.conf.eg +++ b/etc/sensors.conf.eg @@ -497,8 +497,11 @@ chip "via686a-*" # says to what your BIOS says when you boot up), please let us know so we can # improve. -# On the Tyan S1598, the 2.5V sensor reads 0 and is not displayed in the BIOS, -# so you may want to ignore it here. +# On the Tyan S1598, the 2.5V sensor reads 0 and is not displayed in the BIOS. +# Also, Linas Vepstas reports that this sensor shows +# nothing of interest on the Abit KA7 (Athalon), and is also not displayed +# in the BIOS. So, if you have either of these boards may want to uncomment +# the 'ignore 2.5V' line below. label "2.0V" "CPU core" label "2.5V" "+2.5V" @@ -510,9 +513,17 @@ chip "via686a-*" label fan1 "CPU Fan" label fan2 "P/S Fan" +# VIA suggests that temp3 is an internal temp sensor for the 686a. However, +# on the Tyan S1598 as well as the Abit KA7 (Athalon), the absolute values +# of the readings from that sensor are not valid. The readings do seem to +# correlate with temp changes, but the conversion factor may be quite +# different from temp1 & temp2 (as noted above, VIA has not provided +# conversion info). So, you may wish to 'ignore temp3'. + label temp1 "SYS Temp" label temp2 "CPU Temp" label temp3 "SBr Temp" + #ignore temp3 # Set your CPU core limits here. For the other voltage sensors, the # built-in defaults should be fine.