From 2096026dd78cfb1c944d6a4fb8cab8f6e2b2b418 Mon Sep 17 00:00:00 2001 From: Jean Delvare Date: Fri, 26 Sep 2003 21:02:50 +0000 Subject: [PATCH] Add some comments about the Asus A7V8X-X. git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@1999 7894878c-1315-0410-8ee3-d5d059ff63e0 --- etc/sensors.conf.eg | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-) diff --git a/etc/sensors.conf.eg b/etc/sensors.conf.eg index 53554999..20a344de 100644 --- a/etc/sensors.conf.eg +++ b/etc/sensors.conf.eg @@ -1281,7 +1281,7 @@ chip "it87-*" "it8705-*" "it8712-*" # and is not supported by driver at this time ignore vid -# If 3.3V reads 2X too high (Soyo Dragon, for example), +# If 3.3V reads 2X too high (Soyo Dragon and Asus A7V8X-X, for example), # comment out following line. compute in2 2*@ , @/2 # @@ -1320,6 +1320,9 @@ chip "it87-*" "it8705-*" "it8712-*" # you probably need to change the sensor type. This must be done # with 'modprobe it87 temp_type=0xXX', you can't fix it in this file. # See ../doc/chips/it87 for details and valid 'XX' values!!! +# Also, note that on some motherboards (Asus A7V8X-X for example), temp1 is +# the CPU temp and temp2 is the MB temp. On that same motherboard, temp3 +# should be ignored since it is not used. # label temp1 "Temp1/MB" set temp1_over 40