From a0b32bc9cc1a6b282f474fd944750e1862c3ec1b Mon Sep 17 00:00:00 2001 From: "Mark D. Studebaker" Date: Sat, 28 Aug 1999 19:05:36 +0000 Subject: [PATCH] (mds) updated short instructions git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@538 7894878c-1315-0410-8ee3-d5d059ff63e0 --- INSTALL | 11 ++++++----- 1 file changed, 6 insertions(+), 5 deletions(-) diff --git a/INSTALL b/INSTALL index de3d69e9..424e3c82 100644 --- a/INSTALL +++ b/INSTALL @@ -7,15 +7,16 @@ INSTALLATION - SHORT INSTRUCTIONS - NON-KERNEL INSTALLATION - rmdir i2c - ln -s ../i2c i2c - cd i2c - - make (ignore 'no such file or directory' warnings) + - make (ignore 'no such file or directory' warnings) - (as root) make install - cd ../lm_sensors2 - - make (ignore 'no such file or directory' warnings) + - make (ignore 'no such file or directory' warnings) - (as root) make install - - prog/mkdev/mkdev.sh (makes the devices in /dev) - - prog/detect/sensors-detect (determines installed hardware) + - (as root) prog/mkdev/mkdev.sh (makes the devices in /dev) + - (as root) prog/detect/sensors-detect (determines installed hardware) - Place the 'modprobe' commands output by sensors-detect in a - boot file like /etc/rc.d/rc.multi + boot file like /etc/rc.d/rc.multi. + Make sure it is after 'depmod -a -e' is run. - After those commands, put the line 'sensors -s' in the boot file to initialize the sensors at boot time - Place the lines output by sensors-detect in the module