A few small documentation updates, and an updated example config file

git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@139 7894878c-1315-0410-8ee3-d5d059ff63e0

doc/FAQ

@@ -395,10 +395,9 @@ the provided 'sensors' program) instead.
 
 	This is a bit intricate right now. In the near future, this can be
 done through the 'sensors' program, which will take account of the
-computations specified in the configuration file. This will probably not
-be implemented in time for 2.1.0, though.
-	At this moment, you have to cat values to /proc/sys/dev/sensors/*/*
-files, and do any computations by hand. Sorry.
+computations specified in the configuration file. At this moment, you must
+also put the 'set' commands into the configuration file. This will get
+easier in newer versions.
 
 
 4.15 Some sensors are doubly detected?

doc/progs

@@ -20,7 +20,8 @@ this package.
 There are some programs distributed with Simon Vogl's i2c package too:
 * i2c/detect/detect (written in C, not installed)
   This program needs module `i2c-dev.o' to be loaded. It scans the complete
-  address range of a certain bus for connected devices.
+  address range of a certain bus for connected devices. It will only work
+  for i2c-level drivers (not for PIIX4 busses).
 * i2c/eeprom/eeprom (written in C, not installed)
   This program needs the i2c `eeprom.o' module (that is the one that is not
   installed; it can be found in the i2c/drivers/ directory). It reads from