From f37df0e2a741336d14988b77d82632efcbeca953 Mon Sep 17 00:00:00 2001 From: Jean Delvare Date: Sun, 18 Jan 2004 18:06:43 +0000 Subject: [PATCH] Update 4.20, as suggested in ticket #1526. git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@2233 7894878c-1315-0410-8ee3-d5d059ff63e0 --- doc/FAQ | 31 +- doc/lm_sensors-FAQ.html | 1630 ++++++++++++++++++++++----------------- doc/lm_sensors-FAQ.texi | 7 +- 3 files changed, 936 insertions(+), 732 deletions(-) diff --git a/doc/FAQ b/doc/FAQ index 9d4224e0..d05b76e9 100644 --- a/doc/FAQ +++ b/doc/FAQ @@ -1,3 +1,21 @@ +START-INFO-DIR-ENTRY +* lm_sensors-FAQ: (lm_sensors-FAQ) The lm_sensors FAQ +END-INFO-DIR-ENTRY + +Short Contents +************** + +lm_sensors +1 PC and Sensor Overview +2 Sensor and Bus Basics +3 Installation and Management +4 Problems +5 How to Ask for Help +6 How to Contribute +7 Version 1 Specific Questions +Appendix A Revision History of This Document + + Table of Contents ***************** @@ -937,15 +955,17 @@ address. You must select an address that is not in use. `cat 4.20 Sensors says `Can't access procfs/sysfs file' ================================================== - * (release 2.6.0 and later) Did you `modprobe i2c-proc'? Check - `lsmod'. + * (Linux 2.6) Did you `modprobe i2c_sensor'? Check `lsmod'. - * (release 2.5.5 and earlier) Did you 'modprobe sensors'? Check - 'lsmod'. + * (Linux 2.4) Did you `modprobe i2c-proc'? Check `lsmod'. * If you did `sensors -s', did you run it as root? - * Do you have `/proc' support in your kernel (is `/proc' there?) + * (Linux 2.6) Do you have sysfs support in your kernel (is `/sys' + there and populated)? + + * (Linux 2.4) Do you have procfs support in your kernel (is `/proc' + there and populated)? 4.21 Sensors says `No sensors found!' ===================================== @@ -1506,4 +1526,3 @@ Appendix A Revision History of This Document * Rev 1.1 Modifications by Philip Edelbrock, 19980809 * Rev 1.0 Written by Philip Edelbrock, 19980803 - diff --git a/doc/lm_sensors-FAQ.html b/doc/lm_sensors-FAQ.html index f64dbe8c..dbca7a81 100644 --- a/doc/lm_sensors-FAQ.html +++ b/doc/lm_sensors-FAQ.html @@ -1,28 +1,47 @@ - + + Sensors FAQ for lm_sensors version 2.10 - - - - - -

C

opyright (c) 1998 - 2002
+ + + + + +

Sensors FAQ for lm_sensors version 2.10

+Copyright (c) 1998 - 2002
Frodo Looijaard,
Philip Edelbrock,
and
Mark Studebaker
-

Table of Contents

+
+

Short Contents

+
+ + +
+

Table of Contents

+ +
  • 2 Sensor and Bus Basics -
  • 3 Installation and Management +
    • +
  • 3 Installation and Management +
  • 3.3 Which modules should I insert?
  • 3.4 Do I need the configuration file /etc/sensors.conf? +
  • 3.5 What about the No such file or directory warnings when I compile?
  • 3.6 I get all kinds of weird compilation errors? +
  • 3.7 It still does not compile or patch!
  • 3.8 make install fails on Mandrake kernels
  • 3.9 I get unresolved symbols when I modprobe modules (Red Hat especially)
  • 3.10 I2C_DRIVERID_ADM1024 undefined (Red Hat especially) - -
  • 4 Problems +
    • +
  • 4 Problems
  • 4.2 Why do my two LM75's report "-48 degrees"?
  • 4.3 Why do I have two Vcore readings, I have only one processor!
  • 4.4 How do those ALARMS work? The current value is within range but there is still an ALARM warning! @@ -83,7 +102,7 @@ and
  • 4.14 How do I set new limits? +
  • 4.15 Some sensors are doubly detected?
  • 4.16 I ran sensors-detect, but now I get very strange readings?!?
  • 4.17 Bad readings from particular chips @@ -98,12 +117,12 @@ and
  • 4.17.8 Bad readings from LM78!
  • 4.17.9 Bad readings from LM80!
  • 4.17.10 Bad readings from it87! - +
  • 4.18 How do I configure two chips (LM87) differently?
  • 4.19 Dmesg says Upgrade BIOS! I don't want to! +
  • 4.20 Sensors says Can't access procfs/sysfs file
  • 4.21 Sensors says No sensors found!
  • 4.22 Sensors output is not correct! @@ -112,13 +131,13 @@ and
  • 4.23.1 What is at I2C address 0x69?
  • 4.23.2 What is at I2C addresses 0x50 - 0x57?
  • 4.23.3 What is at I2C addresses 0x30 - 0x37? - +
  • 4.24 Sensors-detect doesn't work at all +
  • 4.25 Sensors says Error: Line xxx: zzzzzzz
  • 4.26 Sensors only gives the name, adapter, and algorithm for my chip
  • 4.27 Sensors says ERROR: Can't get xxxxx data! @@ -131,11 +150,11 @@ and
  • 4.31.2 Tyan 2460, 2462
  • 4.31.3 Tyan 2466
  • 4.31.4 Tyan 2688 - +
  • 4.32 Problems on particular systems
  • 4.33 Problems on 2.6 kernels - -
  • 5 How to Ask for Help +
    • +
  • 5 How to Ask for Help -
  • 6 How to Contribute +
    • +
  • 6 How to Contribute -
  • 7 Version 1 Specific Questions +
    • +
  • 7 Version 1 Specific Questions -
  • Appendix A Revision History of This Document - +
    • +
  • Appendix A Revision History of This Document +
    • +
    +

    Node:Top, -Next:, -Up:(dir) +Next:, +Up:(dir)
    +
    -

    lm_sensors

    +

    lm_sensors

    -

    The lm_sensors package includes a collection of modules for general SMBus +

    The lm_sensors package includes a collection of modules for general SMBus access and hardware monitoring. NOTE: this requires special support which is not in standard 2.2-vintage kernels. -