Copy sysctl enums to chip drivers from sensors.h for now,
as seen in drivers included in 2.5 tree. File no longer included
from kernel side.
Apply i2c-proc change in CVS tagged -km2.
Partial clean and sort of includes everywhere.
Add i2c-dev.h, as a partial copy from i2c.
Add to sensors.h from i2c-proc.h to compile things.
Remove i2c-isa.h.
Reflect header file changes to lib/ and prog/.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@1705 7894878c-1315-0410-8ee3-d5d059ff63e0
Module refcounting using .owner, removing of inc/dec_use.
These require (yet unreleased) i2c 2.8.0+.
Named initializers everywhere. Unified namespace.
Cleanup for 2.5, remove EXPORT_NO_SYMBOLS, declare everything
static. Apply initcalls.
PCI device registration changes for busses started, replicating
from i2c-amd*. While everything does compile, nothing really
works. Well, maybe i2c-amd* ported back from 2.5 tree.
After updating your work directory, run
> cvs diff -u -r LAST-PRE-2-8-I2C > lm-2.8-patches-1
BEWARE: I have not even insmoded any of these yet.
To compile, you need i2c from cvs too.
For 2.4 kernel :
> cvs co -r lk2-4 i2c
For 2.5 kernel :
> cvs co i2c
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@1698 7894878c-1315-0410-8ee3-d5d059ff63e0
SMBus controller at a time. This is basically an insurance policy. The
kernel and the status from the SMBus controller should handle this but
observed behavior seems to indicate that the SMBus controller does not
ALWAYS mark itself as "busy" during a transaction especially if a trans-
action fails.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@920 7894878c-1315-0410-8ee3-d5d059ff63e0
to check the "command completed" flag before checking for error flags in
the status register. This will insure that when both conditions exist
(command not completed && error conditions present), a "kill" command will
be executed on the SMBus controller to clean up the bus. Also, added a
status register write after "kill" and "timeout" commands to insure that
the status gets cleaned up after a bad transaction. This change fixes
observed behavior in which a "command never completed" transaction was
always followed by an "idle wait timeout" on the next subsequent trans-
action.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@919 7894878c-1315-0410-8ee3-d5d059ff63e0
Mark M. Hoffman