to check the "command completed" flag before checking for error flags in
the status register. This will insure that when both conditions exist
(command not completed && error conditions present), a "kill" command will
be executed on the SMBus controller to clean up the bus. Also, added a
status register write after "kill" and "timeout" commands to insure that
the status gets cleaned up after a bad transaction. This change fixes
observed behavior in which a "command never completed" transaction was
always followed by an "idle wait timeout" on the next subsequent trans-
action.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@919 7894878c-1315-0410-8ee3-d5d059ff63e0
Dan Eaton