* Better VDD internal computation, as described in the data sheet;
* Fixed the config file to reflect the above change;
* The library read the wrong file to get its gl518sm alarm data.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@150 7894878c-1315-0410-8ee3-d5d059ff63e0
* (module) VIN limits are now set to sane values (3V instead of 30V, which
caused nasty overflows)
* (module) VIN limits had min/max swapped in gl518_attach_adapter
* (lib) TEMP_HYST used the VID sysctl instead of the TEMP sysctl, leading
to bogus readings
* (sensors) print n/a for gl518 not available readings.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@145 7894878c-1315-0410-8ee3-d5d059ff63e0
This file consists of two numbers: the first is either 0 (global sound
alarm disable) or 1 (enable), the second is in the same encoding as the
'alarm' file and determines for which alarms the speaker will sound.
The new file was added to the module, the library and the sensors application.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@112 7894878c-1315-0410-8ee3-d5d059ff63e0
* Turned the i2c noise level down, by setting the debug_level in algo-bit.c
and i2c-core.c to 0 instead of 1. This should stop it from polluting
the dmesg output, as it does at this moment.
* Renamed gl518-r?0-* entries to gl518sm-r?0-*
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@82 7894878c-1315-0410-8ee3-d5d059ff63e0
Strangly enough, both these devices use a high byte, low byte order for
word-sized reads and writes. The SMBus documentation specifies the
reverse (low, high) order, though. If all devices use the high,low order,
we should change this in smbus.c.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@64 7894878c-1315-0410-8ee3-d5d059ff63e0
* Alarms may now work (sound signal disabled, though)
* Revision 0x80 should be recognized and handled correctly
* If fan unconnected, it should show 0 instead of -1 now
Note that this driver will not support GL520SM chips; that chip is different
enough that it deserves its own driver.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@61 7894878c-1315-0410-8ee3-d5d059ff63e0
To be done: support for GL518SM revision 0x80 and GL520SM
Kyösti, if you have some time soon, could you please test it?
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@56 7894878c-1315-0410-8ee3-d5d059ff63e0
Kyosti Malkki