Kernel driver `i2c-i801.o' Status: Beta. Block reads/writes untested (but not used by any current chip driver). Supported adapters: * Intel 82801AA and 82801AB (ICH and ICH0 - part of the '810' and '810E' chipsets) Datasheet: Publicly available at the Intel website Author: Frodo Looijaard , Philip Edelbrock , and Mark Studebaker Module Parameters ----------------- * force: int Forcibly enable the ICH. DANGEROUS! * force_addr: int Forcibly enable the ICH at the given address. EXTREMELY DANGEROUS! Description ----------- The ICH (properly known as the 82801AA) and ICH0 (82801AB) are Intel chips that are a part of Intel's '810' chipset for Celeron-based PCs and '810E' chipset for Pentium-based PCs. The ICH contains up to SEVEN separate PCI functions in TWO logical PCI devices. An output of lspci will show something similar to the following: 00:1e.0 PCI bridge: Intel Corporation: Unknown device 2418 (rev 01) 00:1f.0 ISA bridge: Intel Corporation: Unknown device 2410 (rev 01) 00:1f.1 IDE interface: Intel Corporation: Unknown device 2411 (rev 01) 00:1f.2 USB Controller: Intel Corporation: Unknown device 2412 (rev 01) 00:1f.3 Unknown class [0c05]: Intel Corporation: Unknown device 2413 (rev 01) The SMBus controller is function 3 in device 1f. Class 0c05 is SMBus Serial Controller. The ICH chips are quite similar to Intel's PIIX4 chip, at least in the SMBus controller. See the file i2c-piix4 for details. ********************** The lm_sensors project gratefully acknowledges the support of Texas Instruments in the development of this driver.