mirror of
https://github.com/lm-sensors/lm-sensors.git
synced 2026-10-25 12:14:33 +00:00
Mark D. Studebaker
ad2705bd37
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@1647 7894878c-1315-0410-8ee3-d5d059ff63e0
56 lines
1.5 KiB
Plaintext
56 lines
1.5 KiB
Plaintext
Kernel driver `i2c-ipmb.o'
|
|
|
|
Status: IN DEVELOPMENT - DOESN'T WORK AT ALL - DON'T BOTHER TRYING IT
|
|
|
|
Supported adapters:
|
|
* IPMI BMC
|
|
|
|
Author: Mark D. Studebaker <mdsxyz123@yahoo.com>
|
|
|
|
|
|
Module Parameters
|
|
-----------------
|
|
(none)
|
|
|
|
|
|
Description
|
|
-----------
|
|
This is an adapter which provides access to the IPMB
|
|
(Intelligent Platform Management Bus) and other I2C / SMBus busses
|
|
behind the BMC (Baseboard Management Controller) via
|
|
IPMI (Intelligent Platform Management Interface).
|
|
|
|
This provides low-level access to all devices on busses
|
|
behind the BMC. For high-level access to sensors known
|
|
to the BMC, use the i2c-ipmi and bmcsensors modules.
|
|
|
|
This module REQUIRES the IPMI kernel patch by Corey Minyard,
|
|
v13 or higher, available at http://openipmi.sourceforge.net .
|
|
Other IPMI drivers are not supported.
|
|
|
|
See http://www.intel.com/design/servers/ipmi/ for
|
|
IPMI standards information.
|
|
|
|
You must configure the following features in your kernel
|
|
(under Character Devices):
|
|
IPMI top-level message handler
|
|
IPMI KCS handler
|
|
The IPMI device interface and IPMI watchdog handler are not required.
|
|
|
|
If the KCS handler (ipmi_kcs_drv) is configured as a module,
|
|
you must modprobe it separately, it will not load automatically
|
|
when you modprobe i2c-ipmi or ipmi_msghandler (unless you set up
|
|
/etc/modules.conf to load ipmi_kcs_drv when ipmi_msghandler is loaded).
|
|
|
|
Issues
|
|
------
|
|
Only one BMC is supported - shouldn't be a problem.
|
|
|
|
Alpha!
|
|
|
|
|
|
|
|
**********************
|
|
The lm_sensors project gratefully acknowledges the support of
|
|
Hewlett Packard (Ft. Collins) in the development of this driver.
|