Move mip into mip/

examples/stm32/nucleo-f746zg-baremetal/Makefile

@@ -10,8 +10,7 @@ CFLAGS  ?=  -W -Wall -Wextra -Werror -Wundef -Wshadow -Wdouble-promotion \
 						-mcpu=cortex-m7 -mthumb -mfloat-abi=softfp -mfpu=vfpv4 $(EXTRA)
 LDFLAGS ?= -Tlink.ld -nostartfiles -nostdlib --specs nano.specs \
 					 -lc -lgcc -Wl,--gc-sections -Wl,-Map=$@.map
-SOURCES = boot.c main.c syscalls.c $(ROOT)/drivers/mip_driver_stm32.c \
-					$(ROOT)/mongoose.c
+SOURCES = boot.c main.c syscalls.c $(ROOT)/mongoose.c
 
 all build example: $(TARGET).bin
 

examples/stm32/nucleo-f746zg-baremetal/main.c

@@ -2,8 +2,6 @@
 // All rights reserved
 
 #include "mcu.h"
-
-#include "drivers/mip_driver_stm32.h"
 #include "mongoose.h"
 
 #define LED1 PIN('B', 0)   // On-board LED pin (green)
@@ -138,11 +136,7 @@ int main(void) {
   // For static configuration, specify IP/mask/GW in network byte order
   struct mip_ipcfg ipcfg = {
       .mac = {0xaa, 0xbb, 0xcc, 1, 2, 3}, .ip = 0, .mask = 0, .gw = 0};
-  struct mip_driver stm32_driver = {.init = mip_driver_stm32_init,
-                                    .tx = mip_driver_stm32_tx,
-                                    .rxcb = mip_driver_stm32_setrx,
-                                    .status = mip_driver_stm32_status};
-  mip_init(&mgr, &ipcfg, &stm32_driver);
+  mip_init(&mgr, &ipcfg, &mip_driver_stm32);
   MG_INFO(("Init done, starting main loop"));
 
 #if defined(DASH)

examples/uart-bridge/net.c

@@ -11,6 +11,10 @@ static int s_rx = 4;
 static int s_tx = 5;
 static int s_baud = 115200;
 
+void uart_init(int tx, int rx, int baud);
+int uart_read(char *buf, size_t len);
+void uart_write(const void *buf, size_t len);
+
 // Let users define their own UART API. If they don't, use a dummy one
 #if defined(UART_API_IMPLEMENTED)
 #else