add f71882fg sensors.conf.eg entry

git-svn-id: http://lm-sensors.org/svn/lm-sensors/branches/lm-sensors-3.0.0@4580 7894878c-1315-0410-8ee3-d5d059ff63e0

etc/sensors.conf.eg

@@ -2848,3 +2848,50 @@ chip "dme1737-*"
 #   set fan4_min 1000
 #   set fan5_min 1000
 #   set fan6_min 1000
+
+
+#
+# sample configuration for the Fintek f71882fg and f71883fg
+#
+# The configuration below is for the Epox EP-9U1697 GLI board, which has a
+# Fintek f71883fg relabeled as Epox ep1308, this is the default config as this
+# driver is developed and tested on an Epox EP-9U1697 GLI board.
+#
+# Premade configurations for other boards can be found at:
+# http://www.lm-sensors.org/trac/wiki/Configurations/
+# If your motherboard isn't listed there and you create a configuration for it
+# please add it there.
+#
+chip "f71882fg-*"
+
+# Temperature
+    label temp1       "CPU"
+    label temp2       "System"
+    ignore temp3
+
+# Fans
+    label fan1        "CPU"
+    ignore fan2
+    ignore fan3
+    ignore fan4
+
+# Voltage
+    label in0         "3.3V"
+    label in1         "Vcore"
+    label in2         "Vdimm"
+    label in3         "Vchip"
+    label in4         "+5V"
+    label in5         "12V"
+    label in6         "5VSB"
+    label in7         "3VSB"
+    label in8         "Batery"
+
+# never change the in0, in7 and in8 compute, these are hardwired in the chip!
+    compute in0       (@ * 2), (@ / 2) 
+    compute in2       (@ * 2), (@ / 2)
+    compute in3       (@ * 2), (@ / 2)
+    compute in4       (@ * 5.25), (@ / 5.25)
+    compute in5       (@ * 12.83), (@ / 12.83)
+    compute in6       (@ * 5.25), (@ / 5.25)
+    compute in7       (@ * 2), (@ / 2)
+    compute in8       (@ * 2), (@ / 2)