Add comment to sensors.conf.eg about the need to comment the in# compute lines for the fscher when using the fschmd driver

git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@4981 7894878c-1315-0410-8ee3-d5d059ff63e0

etc/sensors.conf.eg

@@ -1852,6 +1852,9 @@ chip "fscher-*"
     label in1         "+5V"
     label in2         "Battery"
 
+# Note: comment the compute lines below when using the newer unified fschmd
+# driver, as that driver does the scaling in the driver
+
 # Compute Voltages using mainboard dependant MRO-values
 # (see doc/chips/fscher)
 #                           M    R             O               O                  M    R
@@ -1862,6 +1865,10 @@ chip "fscher-*"
 # Read documentation before enabling pwm settings (see doc/chips/fscher)
 # WARNING: IMPROPER VALUES MAY DAMAGE YOUR SYSTEM DUE TO OVERHEATING!
 
+# Note these set statements will not work with the newer unified fschmd driver
+# The functionality is still available using standard sysfs attributes for
+# pwm control: pwm#_auto_point1_pwm (which are not accessible through sensors)
+
 # Allow fans to turn off
 #    set pwm1          0
 #    set pwm2          0