Make it clear that the gl518sm "iterate" trick is gone in the

Linux 2.6 driver (ticket #1767).


git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@2681 7894878c-1315-0410-8ee3-d5d059ff63e0

doc/chips/gl518sm

@@ -45,6 +45,10 @@ IMPORTANT: For the revision 0x00 chip, the
            unless you use the slow 'iterate' method. Limits will still
            work even when iterate=0. See below. This is a limitation
            of the chip, not the driver.
+           Note that the 'iterate' method was trimmed while porting the
+           driver to Linux 2.6 as we considered it too ugly for the thin
+           benefit.
+	   
 
 This driver supports the Genesys Logic GL518SM chip. There are at least
 two revision of this chip, which we call revision 0x00 and 0x80. Revision
@@ -112,6 +116,9 @@ You may also set the iteration type with
 If you have a rev 0x80 chip, the in0-in2 inputs are readable.
 In this case, 'iterate' will be read-only and the read value is 3.
 
+This does NOT apply to the Linux 2.6 kernel driver, where the 'iteration'
+code was dropped for being too ugly.
+
 
 Chip Features
 -------------