Michael Hufer <michael.hufer@freenet.de>
------------------------
> First, I added a new mod parameter "reset_it87" which controls whether
> or not the chip is reset on module load (modprobe it87 reset_it=1,
> default) or not(modprobe it87 reset_it87=0).
> Since this worked out quiet nicely I decided to go one step further
> and also add the chips manual and automatic temperature controlled fan
> speed features (PWM etc.).
>
> Finally I also updated the doc to document the new features.
>
> Attached is a diff against the current cvs version.
------------------------
Subject:
Re: fan speed for it87?? chips added
Date:
Fri, 26 Sep 2003 23:28:35 +0200
From:
Michael Hufer <michael.hufer@freenet.de>
To:
sensors@Stimpy.netroedge.com, Jean Delvare <khali@linux-fr.org>
On Friday 26 September 2003 22:40, Jean Delvare wrote:
> > I found and fixed the little problem I had with the original chip
> > initialization. I can now load the module with reset_it87=0 and
> > init=1 without messing up the settings of the power supply fan
> > from the BIOS. It was quite simple after all.
>
> I'm interested in details, can you tell us what it was?
Sure, it actually was something I introduced myself :-(. I initialized the
fan_ctl register with (read_value & 0x8f | 0x77) to enable the smart
guardian feature for all 3 fans. But the power supply fan does not support
pwm. It can only be operated in on/off mode, i.e. bit 0 must be clear. I
switched it back to the original (rv & 0x8f | 0x70 ) and everything is back
to working.
> > Do you want me to send the latest diff?
>
> Sure I want.
Here it comes.
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@2033 7894878c-1315-0410-8ee3-d5d059ff63e0
The following patch does the following:
Fixed bug with not all alarms enabled.
Added ability to read battery voltage
Select temperature sensor type at module load time.
Added setting for Inside Technologies 786LCD board to example config file
I also fixed what looked like a typo in the existing it87 section where
in6_min/max was set twice and in7 was not set. As commented I think
the equation for the negative voltages are wrong but without that motherboard
I can't verify.
With the 786LCD board sensors-detect reports a lm78 which doesn't
exist and a sis5595 which may be part of the SIS630 chip but doesn't
perform the monitoring. The it8705F/SIS950 which is on the board is
reported as a misdetect. I didn't know enough about the various chips
to figure out how to get correct detections.
David Gesswein
git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@1146 7894878c-1315-0410-8ee3-d5d059ff63e0
Jean Delvare