add entry for dual lm87's requiring different configuration

git-svn-id: http://lm-sensors.org/svn/lm-sensors/trunk@1035 7894878c-1315-0410-8ee3-d5d059ff63e0
This commit is contained in:
Mark D. Studebaker committed 2001-02-25 00:45:28 +00:00
1 parent 448fe0c52c
commit 08883f7958
1 file changed
+20 -4
+20 -4
View File
@@ -65,6 +65,7 @@ sensor reading results. Why?
4.17A Bad readings from the AS99127F!
4.17B Bad readings from the VIA 686A!
4.17C Bad readings from the MTP008!
4.18 How do I configure two chips (LM87) differently?
4.19 Dmesg says Upgrade BIOS! I don't want to!
4.20 Sensors says 'Can't access /proc file'
4.21 Sensors says 'No sensors found!'
@@ -411,7 +412,7 @@ readings.
4.3 Why do I have two Vcore readings, I have only one processor!
The LM78 family has seven voltage sensors. The default way of
The LM78 has seven voltage sensors. The default way of
connecting them is used in the configuration file. This includes a VCore2,
even if you do not have one. You can easily edit the configuration file
to give it another name, or (in upcoming versions) to make this reading
@@ -612,6 +613,19 @@ If your sensor type does not match the default, you will have to change it.
See doc/chips/mtp008 for details.
4.18 How do I configure two chips (LM87) differently?
There is a SuperMicro board with two LM87's on it that are
not hooked up in the same way, so they need different defaults.
For example, both CPU temperatures go to one LM87.
Make two different sections in /etc/sensors.conf as follows:
chip "lm87-i2c-*-2c"
put configuration for the chip at 0x2c here
chip "lm87-i2c-*-2d"
put configuration for the chip at 0x2d here
4.19 Dmesg says Upgrade BIOS! I don't want to!
If the problem is a PCI device is not present in 'lspci', the solution
@@ -687,13 +701,15 @@ prog/eeprom/decode-dimms.pl to get more information than you ever wanted.
These are often 'shadows' of you EEPROMs on your SDRAM DIMMs
at addresses 0x50 - 0x57. They aren't really there. If you try and
do a 'i2cdump' on them you won't get anything. This is probably
caused by some timing problem on your motherboard or on the DIMMs.x
caused by some timing problem on your motherboard or on the DIMMs.
We don't know the exact cause.
4.24 Sensors-detect doesn't work at all
It could be many things. What was the problem? See below.
It could be many things. What was the problem? See below
in questions 4.24 A-C.
4.24A Sensors-detect says "Couldn't open /proc/bus/i2c?!?"
@@ -854,7 +870,7 @@ can not be sure.
---------------------------------------------------------------------------------------
---------------------------------------------------------------------------------------
Rev 2.3 (MDS) General update, 20010219
Rev 2.3 (MDS) General update, 20010224
Rev 2.2 (Frodo) Corrections for lm_sensors 2.4, 19990920
Rev 2.1 (Frodo) Corrections for lm_sensors 2.2, 19990112
Rev 2.0 (Frodo) Major revision for lm_sensors 2.1, 19981229