This adds a config file for the MSI X370 SLI Plus. Similiar models may
work with derived configurations.
[olysonek: fixed up 'compute in3' statement, fixed up whitespace,
reformatted description]
Apparently, Gigabyte uses a 8kOhm and a 2.7kOhm resistor for the
voltage divider (both are commercially available SMD resistors). It
matches my BIOS reading.
Applied from PR
https://github.com/lm-sensors/lm-sensors/pull/203
[olysonek: squashed commits, updated description]
This motherboard supports one external temperature sensor. When there isn't
anything connected it shows very low values (e.g. -55C in my case).
Signed-off-by: Karol Grudziński <krlgrudzinski@gmail.com>
According to:
"Quad-Core Intel® Xeon(R) Processor 5400 Series Electrical Specifications"
(table 2-12), FSB termination voltage of the CPUs (VTT) is 1.1V +/-5%.
Initial configuration set it to 1.2V - fix that.
Signed-off-by: Lech Perczak <lech.perczak@gmail.com>
Add configuration for Supermicro X7DCL motherboard.
Based on slightly modified setup of X7DBE from this repo.
Runtime tested on X7DCL-3 rev. 1.1a
So far there is only support for onboard sensors,
no support for PSU failure yet, nor external PMBus sensors.
Signed-off-by: Lech Perczak <lech.perczak@gmail.com>
Input routing and scaling for this board was read from schematic of a
similar MSI MS-7B00 (B350 Gaming Pro Carbon) board.
temp5 on the MS-7B00 schematic is a thermistor under the B350 chip itself.
However, on my MS-7A34 board the reading is stuck at 23°C.
Judging from MS-7A34 board sensor readings that other people had posted
online the sensor seems to work properly for them, so I have left it
enabled.
Signed-off-by: Maciej S. Szmigiero <mail@maciej.szmigiero.name>
Input routing and scaling for this board was read from its schematic,
verified on a real specimen.
This config is likely also valid for other members of GA-F2A88XM-x family,
as differences between them seem pretty minor.
It might also be valid for GA-F2A85XM-HD3 board considering that
GA-F2A88XM-HD3 schematic has the former board name as title in many places.
Signed-off-by: Maciej S. Szmigiero <mail@maciej.szmigiero.name>
Values as per nuvoton nct6779D datasheetSection 8.5 Analog Inputs (Page 54,55).
Is based on nct6779 which uses a 2.048V input range, all inputs above that are scaled using a voltage divider.
Specific inputs like the ADC, AVCC, VBAT, 3VSB and 3VCC utilize an integrated voltage divider.
Signed-off-by: Rigo Reddig <rigo.reddig@gmail.com>
Reiner Buehl